Missile and Munitions Editing and Proofreading Services

When a test round fails to reach its target, the investigation report may conclude within a week that the guidance software had a known limitation under the wind conditions present that day. What the report may not establish, because no one checked, is whether the round tested was built correctly to the specification said to have that limitation, or whether a manufacturing defect in that particular unit is being explained by a far more convenient and less expensive design theory that was already available.

The documents we edit for Missile and Munitions

We edit the documents test engineers and safety boards produce after munitions and missile test failures: test failure investigation reports, hazard classification and safety case documentation, malfunction and dud reports, technical data package and specification correspondence, range safety documentation, and the corrective action plans that follow a confirmed design or manufacturing finding. Our editors work on the report that determines whether a fleet is grounded, a supplier receives a demand for corrective action, or nothing happens.

What the editing involves

A failure investigation exists to distinguish a test escape from a design defect, and the characteristic failure is a conclusion reached before the two have been separated. The failure of a single test article does not by itself indicate which has occurred. We revise these reports so that the test article is checked against its own build records and inspection data before any conclusion is drawn about the design, since a manufacturing defect in one unit and a limitation shared by every unit of a design produce the same outcome on the day but require entirely different corrective actions. The report states explicitly whether other units from the same production lot have been checked or tested or remain in service unexamined, given that a finding confined to "this test article", with nothing said about the rest of the lot, leaves open a question a reader may not recognize as open. A design explanation is supported by evidence that the failure mode has been reproduced or otherwise independently confirmed, rather than accepted because it is consistent with the observed failure, because many different causes are consistent with the same observed failure. The investigation states what was ruled out and how, not only what was concluded, as a conclusion with no visible elimination of alternatives cannot be checked by a later reviewer. Implications for hazard classification are stated specifically rather than deferred, given that a finding with unstated safety implications is treated as informational rather than urgent. The corrective action is matched to the failure mode actually confirmed, since a design change applied to a manufacturing defect, or the reverse, corrects nothing while appearing on paper to have addressed the problem. Reports written in this way identify the actual problem rather than the convenient explanation.

Confidentiality and the limits of our role

All material sent to us is treated in confidence, including test data, technical findings and safety information. We are editors, not test engineers, safety board members or ordnance specialists, and we offer no opinion on causation, safety or corrective action. Our role is to ensure that each report shows its reasoning.

Key Missile and Munitions vocabulary

Missile and Munitions Terminology Check

A short test of specialist terminology. Select the correct answer.

Get a Free Estimate

« More Aerospace, Defense and Space editing  |  All editing services